Filter
Top Products
5
2. Vehicle driving:
SW1: Turn on the Navigation display timer mode. When SW1 is pressed, the LED
will turn yellow. The navigation image will appear for the preset time 30sec, 2.5
minutes or 5 minutes. Once the preset time has expired, the LCD will return to its
previous state. The navigation image will reappear with the next voice command
prompt from the navigation computer.
SW2: Turns the navigation screen image on and off. Press once to turn on the
continuous Navigation display.
Press again to turn off the Navigation display. Then press SW 1 if you want to
engage the Voice command navigation display timer.
SW3: When pressed and held, the rear camera image appears on the mirror. When
released, the LCD will return to its previous appearance.
3. Vehicle Parked:
SW1: Used to turn the LCD on/off when using the AUX video and audio input. The
parking brake must be engaged.
SW2: Used to turn off and on the Navigation image.
SW: 3 When pressed and held, the rear camera image appears on the mirror. When
released the LCD will return back to its previous appearance.
Navigation Voice command display timer: There is a three-position switch located on the
bottom right rear of the mirror/monitor. The three settings are 30 seconds, 150 seconds and
300 seconds. The vehicle operator can select to engage the navigation display timer by
pressing SW 1 while the vehicle is going forward. The LED will turn yellow. The Navigation
Display will appear for the preset time whenever the navigation system issues an audible voice
command.
II. OPERATION
1. The Mirror/monitor is ready for operation every time the Ignition key is turned on.
The mirror/monitor turns off every time the Ignition is turned to the off position.