Filter
Top Products
Page 7
Installation 2: Headliner pins
1. Remove the suction cup by rotating counter clockwise.
2. Locate suitable mounting location on headliner of vehicle.
3. Insert the mounting pin along opposite sides of camera into the headliner.
Push the mounting pins into the headlines until pin hooks are at mounting
tab. Place the pin hooks of mounting pin on mounting tabs.
3. Connect the camera cable to the extension cable provided
with the rear view mirror.
4. Route the camera cable under the headliner of the vehicle.
5. Route the extension cable up to the rearview mirror control box
and plug in the 4-pin connector.
Page 8
Installation 3: View of the Double side adhesive tape.
Page 9
Installation 3: Double sided adhesive tape.
1. Remove the suction cup by rotating counters clockwise.
2. Locate suitable flat mounting location in vehicle that double-sided tape
will adhere to.
3. Remove one side of the protective paper of both pieces of adhesive tape and
adhere tape to back of camera.
4. Remove remaining protective paper and adhere the camera to the selected
mounting location.
5. Connect the camera cable to the extension cable provided with the rear
view mirror.
6. Route the camera cable up to and under the headliner or side panel of the
vehicle.
7. Route the extension cable up to the rearview mirror control box and plug in
the 4-pin connector.