Filter
Top Products
C. Positioning the Slide Control Switch anywhere in the center area will
automatically enable an internal timer. The timer is adjustable
between 10 Seconds (further left) to 3 minutes (further right).
D. When the Navigation System is in guidance mode, every time a turn-
by-turn voice guidance command is received, the Navigation image
will automatically turn on and remain on for the pre-selected time set
by the Slide Switch. After the pre-set time has expired, the
Navigation display will turn off and remain off until the next voice
command is received.
HINT 1: When entering a new address into the Navigation Address Book,
it will be easier to move the Slide Control Switch all the way to the right
to keep the LCD display on until the address has been completed.
HINT 2: When in Timed Display Mode, you can press the “+” or “-“
button on the mirror to turn the Navigation image on for the full extent of
the pre-set time.
4. LCD Monitor Brightness Control
The brightness adjustment control is on the bottom right of the rearview
mirror.
Rotating the wheel to the right will decrease the brightness of the
monitor.
Rotating the wheel to the left will increase the brightness of the monitor.
5.
Disabling the internal speaker
Remove the L-Cover at the left end of the mirror using a Mini
screwdriver (see Figure2), to gain access to the small switch inside.
To disable the internal speaker, set the switch to the off position (See
Figure3). Set the switch to the ON position to enable the internal speaker
on (see Figure3).
Figure2 Figure3
5