Filter
Top Products
128-6190
5 of 6
Page 5
To operate the accessory associated with Channel 3, press and hold the Option button of
your keychain transmitter for four seconds.
NOTE: You may access the Channel 3 command regardless of whether the system is
"locked" or "unlocked", but not when the ignition switch is in the on position. This is to
prevent the output from accidentally opening the vehicle's trunk when the vehicle is in
motion.
ADDITIONAL REMOTE FUNCTION CHANNEL 4
The system has an additional output, (Channel 4) ,that can be connected to a number of
different optional accessories. Some of the more common uses for this channel are:
Remote Engine Start
Remote Window Close
Remote Garage Door Interface
To operate the accessory associated with Channel 4, simultaneously press both buttons of
your keychain transmitter which were configured and progeammed for this function.
NOTE: The channel 4 output will remain active for as long as the transmitter buttons are
held. Certain accessories may take advantage of the extended output capability
of this channel. To discontinue the output, simply release the transmitter buttons.
IGNITION DOOR LOCKING/UNLOCKING
The system is capable of being programmed for the added safety and security of ignition
controlled door locking and unlocking. These features are separate, so the unit may be
programmed for one, or both, or neither.
When the ignition door locking feature is programmed, the system will cause all door locks
to lock whenever the ignition switch is turned from the off to on position, (providing that all
doors are closed at that time). All doors will lock approximately 3 seconds after the vehicle's
ignition switch is turned on. This is a nice feature for maintaining the personal safety of the
occupants of the vehicle, in an effortless and automatic manner.
When the ignition door unlocking feature is programmed, the system will cause all door
locks to unlock whenever the ignition switch is turned from the on to off position. All doors
will unlock immediately after the vehicle's ignition switch is turned off. If 2 Step unlock was
installed, only the driver's door will unlock.
As stated these features are programmed separately, so you may chose to use one, both,
or neither. Please consult with your dealer to consider your options.
TWO STEP UNLOCK (ACCESS GUARD)
By pressing the unlock button of the keychain transmitter as you would normally, (Please
see the section titled "Unlocking The System", earlier in this manual), the system will disarm,
and only the driver's door will unlock. If however, you should then decide instead that you
want all doors to unlock, you can simply press the unlock button a second time and all doors
will unlock.