Filter
Top Products
128-6190
4 of 6
Page 4
Note: In the event that you lose your keychain transmitter or the transmitter fails to operate
the keyless entry system, the valet switch can be used to override the optional Starter
Interrupt and therefore allow the engine to be started. To override system:
1. Open the door with the vehicle's door key.
2. Turn the ignition switch to the on position.
3. Flip the valet/override switch to the on position.
The system will disarm, allowing the engine to be started, and the vehicle to be operated
normally. Always remember to move the valet switch to the off position to allow the passive
arming and optional starter interrupt features to be operable the next time you park the
vehicle.
ELIMINATING THE LOCK/UNLOCK CHIRPS
You can selectively eliminate the normal lock and unlock chirps by holding the transmitter
button slightly longer when locking and unlocking. This will prevent the siren chirps for one
lock or unlock cycle. If you find this inconvenient and wish to eliminate these chirps perma-
nently,
1. Start with the valet switch in the off position.
2. Turn the ignition switch "on" then "off".
3. Within 10 seconds of turning off the ignition, flip the valet switch on, "off", "on", "off", "on",
"off".
4. If the chirps were on before you started, the siren will emit 2 short chirps indicating that
the chirps are now off. If the chirps were off before you started, the siren will emit one
short chirp indicating that the chirps are now on.
REMOTE PANIC OPERATION
The lock and unlock buttons of your keychain transmitter also serves as panic buttons and
will cause the vehicle horn (or optional siren) to sound on demand. To use the panic feature,
you must be within the system's maximum operating range. In an emergency situation, to
use the panic feature, press and hold the lock or unlock button of your keychain transmitter
for 3 seconds. This will cause the lights to flash, the vehicle horn (or optional siren) to sound
and if the optional interior illumination circuit was installed, the interior lights to flash. The
panic mode will continue for 30 seconds and then reset.
To disengage the panic feature before the 30 seconds are up, press and hold the lock or
unlock button of your keychain transmitter for 3 seconds or press the Option button momen-
tarily. The doors can be unlocked or locked while in "panic" feature by momentarily pressing
the lock or unlock button respectively.
ADDITIONAL REMOTE FUNCTION CHANNEL 3
The system has an additional output, (Channel 3) , that can be connected to a number of
different optional accessories. Some of the more common uses for this channel are:
Remote Trunk Release
Remote Window Close