Filter
Top Products
3 WIRE POSITIVE SWITCHED DOOR LOCKS
In this application, the red wire provides a positive pulse during disarming, or the pulsed +12 volt unlock output. Connect
the red wire to the wire that provides a low current positive signal from the factory door unlock switch to the factory door
lock control relay.
The green wire provides a positive pulse during arming, or the pulsed +12 volt lock output. Connect the green wire to
the wire that provides a low current positive signal from the factory door lock switch to the factory door lock control relay.
4 WIRE POLARITY REVERSAL and
5 WIRE ALTERNATING 12 VOLT
DOOR LOCK CONTROL CIRCUITS
In these applications, the AS 9159 Door Lock Interface (or equivalent 30 A automotive relays) must be used.
Refer to the AUDIOVOX Door Lock Wiring Supplement, for proper connection to these types of circuits.
128-4301
COMPLETING THE INSTALLATION:
ANTENNA WIRE: Be sure to extend the thin black antenna wire to its full length, and cable tie into place where it
cannot be damaged. Avoid wrapping this wire around major, high current wire looms.
OPERATION: Take a few moments to check off the appropriate option boxes in the owner’s manual, and to fully
explain the operation of the system to your customer.
WIRE DRESSING: Always wrap the alarm wires in convoluted tubing, or with a spiral wrap of electrical tape.
Secure these looms along the routing using cable ties.
This will ensure that the alarm wires are not damaged by falling onto hot or sharp moving surfaces in the vehicle.