Filter
Top Products
DISARMING THE SYSTEM:
1. As you approach the vehicle, press and release the unlock button on the
keychain transmitter.
2. The siren and or horn will beep two times, the parking lamps will flash two
times, and the red dash mounted LED will turn off, indicating that the
system is DISARMED. If the optional entry illumination feature has been
installed, the vehicle’s interior lights will turn on for 30 seconds,
or until the ignition key is turned on.
NOTE: If your system has been programmed for “ passive arming “, then it
will begin to re-arm immediately after disarming. This is indicated by
a rapid flashing of the red dash mounted LED Opening one of the
vehicle’s doors will suspend the passive arming process until all
doors have been closed, or until the ignition key has been turned on.
INTRUSION WARNING SIGNALS:
The system will inform you if an intrusion attempt has occurred while you were
away from the vehicle. If an intrusion attempt has occurred, the siren and or horn
will beep four times when the system is disarmed. The vehicle’s parking lights will
also flash three times to indicate an intrusion has occurred.
Enter the vehicle and observe the dash mounted LED for further informa
tion.
1. If the LED is flashing one time...pause...one time...pause...etc., then an
intrusion attempt was made to a voltage sensing, light activated entry
point, or to an optional sensor that has
been connected to zone 1.
2. If the LED is flashing two times...pause...two times...pause...etc., then an
intrusion attempt was made to the hood or trunk, or to an optional sensor
that has been connected to zone 2.
3. If the LED is flashing three times...pause...three times...pause...etc.,
then an intrusion attempt was made through one of the vehicle’s doors.
These intrusion warning indicators are stored in the system’s memory, and will
only be erased when the ignition key is turned to the “ on “ position.
OPERATING THE EMERGENCY PANIC:
The buttons on your keychain transmitter will allow you to immediately activate the
alarm in emergency situations. To use the remote panic switch:
1. Press the unlock, then lock, then unlock buttons on your keychain
transmitter within 3 seconds. The alarm will immediately sound, and
continue to sound for 30 seconds.
2. To stop the alarm before the 30 second cycle has expired, simply press
and release the unlock button on your keychain transmitter.