Filter
Top Products
3. In 30 seconds, you will hear a single short chip from the siren, and the
vehicle’s parking lamps will flash one time, indicating that the system has
ARMED. At this time, the red dash mounted LED will begin to flash
slowly, providing a visual indication that the system is fully armed.
4. It is possible to program the system, that when the alarm is allowed to
automatically passive arm, there will be a 15-second delay after a door is
opened before the alarm will sound. However, if the system is pro
grammed for instant trigger there will be no delay. Check with your
installer for the setting of this feature.
IMPORTANT !
When the system is programmed for passive arming, the
system will always arm, even when the keychain transmitter
has not been used to lock the doors. When you leave the
vehicle, and a door has been left opened, the system will
arm after 10 minutes. If you plan to vacuum the car, or if
service work is being performed, either leave the key in the
ignition and switched to the on position, or put the system
into valet mode. If you do not do this, the system will arm
in 10 minutes, and you will probably inadvertently trip the
alarm.
PROTECTION WHILE THE SYSTEM IS ARMED:
1. Opening any door, hood, or trunk will cause the alarm to immedi-
ately sound. The alarm will continue to sound for 30 seconds, then
stop and automatically re - arm the vehicle. If the potential thief left
a door opened, the alarm will sound for five more 30 second cycles,
then re-arm and ignore the opened door zone.
2. Whenever the system is armed, the red dash mounted LED indicator will
slowly flash. This serves as a visual deterrent to the potential thief. The
LED is a very low current bulb, and will not cause the vehicle’s battery to
drain, even when the vehicle is left unattended for extended periods.
3. Whenever the system is triggered, the vehicle’s parking lights will flash
for the 30 second alarm cycle, attracting added visual attention to the
vehicle.
4. Whenever the system is armed, the vehicle’s starter will be disabled.
The vehicle will not start.
5. With shock sensor installed, any strong impact to the vehicle’s glass
will cause the alarm to trigger for the full 30 second alarm cycle.
6. With 2 stage shock sensor installed, any mild impact to the vehicle's
glass will cause the alarm to sound a short series of warning tones.