Congratulations on your purchase of the PRO 9232S automotive Keyless Entry
Upgrade Alarm System. The PRO 9232S is a state -of -the-art auto security system
that is designed to automatically arm and disarm when it receives a command from
your existing Factory Keyless Entry Transmitter. Taking a few moments to read this
manual will help to ensure that your vehicle is protected at all times.
ARMING THE SYSTEM: (ACTIVE)
1. Turn the ignition key off, exit the vehicle, and close all doors.
2. Press and release the Lock button on the keychain transmitter.
3. The siren and or horn will beep one time, the parking lamps will flash one
time, and the red dash mounted LED will begin to slowly flash, indicating
that the system is ARMED.
NOTE: If the unit beeps three times when arming, then one of the entry
points ( hood, trunk, or doors ) has been left opened. Closing the
hood, trunk, or door will correct the problem, and the system will
emit a single chirp to confirm that the problem has been corrected.
Additionally, if illuminated entry is a feature of the Factory Keyless
Entry system, the alarm may chirp 3 times every time the system is
armed, and chirp one additional time when the interior light turns off
to confirm that all trigger zones are fully operational.
4.
Any time the door lock switch in the vehicle is used to lock the doors while
the ignition key is turned off, the system will immediately arm. To lock the
doors after entering the vehicle,
make sure the ignition key is switched on
first. Turning the ignition key on first will stop the system from arming.
ARMING THE SYSTEM: (PASSIVE)
1. Turn the ignition key off, exit the vehicle, and close all doors.
2. The dash-mounted LED will begin to flash rapidly, indicating that the
system is automatically ( passively ) arming. As an added convenience,
the 30 second automatic passive arming will not begin until all doors are
closed, allowing passengers to exit the vehicle at their convenience.
Model PRO 9232S
OWNER’S MANUAL
KEYLESS ENTRY ALARM UPGRADE MODULE