Filter
Top Products
To program these selectable features:
1. Start with the programming switch in the OFF position.
2. Turn the ignition key to the ON position.
3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.
4. Immediately turn the ignition key OFF, then back to ON.
5. Flip the program switch ON - OFF - ON - then OFF.
6. Use button 1 on the transmitter to advance to the feature that you want to change. EXAMPLE - If you need to change
programmable feature number 3, press and release button 1 on the transmitter 3 times in succession. The parking
lights will flash 3 times confirming that selected feature 3 can now be programmed.
7. Use button 2 on the transmitter to change the selection of the programmable feature. If you are not sure what the
setting for any feature is, press button 2 one time, the parking lights will flash once or twice indicating the features
setting.
Note: Once you enter the feature programming mode, do not allow more that 15 seconds to pass between steps, or
the programming will be terminated.
2. Programming Tach Rate:
The PRO- 9171FT Remote Car Starter will learn the tach rate of the vehicle. To learn tach;
1. Start with the programming switch in the OFF position.
2. Turn the ignition key to the ON position.
3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.
4. Immediately turn the ignition key OFF.
5. Flip the program switch ON, then start the vehicle using the ignition key.
6. When the unit senses the tach signal, the parking lights will begin to flash.
7. Flip the program switch OFF. The parking lights will turn on for 3 seconds to indicate that the tach signal is stored
and the unit is now out of the program mode.
3. Diagnostics:
1. Be sure that programmable feature number 7 is set to the "Diagnostics On" mode.
2. First flip the program switch on, then turn the ignition key to the ON position.
3. The lights will flash, and number of flashes will indicate the reason for shutdown on the last remote start
attempt. The indications are as follows.
1 Flash 10 or 15 Minute Run Timer Expired
2 Flashes Low or No Tach Signal (RPM)
3 Flashes Positive Shutdown Wire Activated
4 Flashes Control Switch Moved to Off Position
5 Flashes R.F. ShutdownSignalReceived
6 Flashes High RPMSignalReceived
7 Flashes Negative Shutdown Wire Activated
1. RF Programmable Features:
1 Flash
1 Second Door Locks
10 Minute Run Time
Park Lights Steady On
(No Function)
(No Function)
Ignition 2 Off During Crank
Diagnostics Off
(No Function)
2 Flashes
3.5 Second Door Locks
15 Minute Run Time
Park Lights Flash
Tach Operation
(No Function)
Ignition 2 On During Crank
Diagnostics On
(No Function)
Default
1 Second
10 Minute
Steady
Tach
------------
Off During Crank
Off
-------------
Feature Selection
First
Second
Third
Fourth
Fifth
Sixth
Seventh
Eighth
6