Filter
Top Products
128-8794
19 of 24
Page 19
Battery Indicator: Your transmitter has a battery indicator that is
shown in the upper right corner of the screen as shown left. This icon
indicates a new battery shown with 3 bars. As the battery deterio-
rates, the bars will disappear. 1 bar indicates the battery should be
replaced. Replace battery with a fresh 1.5V AAA battery and dispose
of the used battery properly.
Other icons that will be displayed at times when certain functions and
features are active in the vehicle or on the remote:
Range Indicator. The range indicator will have bars to the side of the
icon if the unit is out of range.
Vibrate Mode On. This icon will be displayed if you select vibrate
instead of tones. To toggle vibrate on and off, press "F" + Unlock
simultaneously.
Alarm Clock. This icon will be toggled on and off when the "F" +
Trunk/Key buttons are pressed simultaneously. The feature must be
set in the feature selection menu of the transmitter.
Timing Count Down. The unit offers an additional count down timer
for situations where an alert tone may be needed to remind you of
something important. Setting information shown on previous page.
Power Save Feature. Press the "F" and Lock buttons simulta-
neously to toggle this feature on and off. With this mode on, the
battery in the transmitter will go into a power down mode when the
unit is disarmed.
Daily Start Timer: (Only available on certain remote start units)
24 Hour Start Timer. Standing at the vehicle at the time you want it to
start, press the option + lock buttons simultaneously for 1 second.
The transmitter will beep and display the 24 hour timer. This is the
time the vehicle will start when you follow the exit procedure. In other
words, if you want the vehicle to start 6AM, at 6AM of any morning, stand-
ing at the vehicle, press and hold the option + lock buttons until you hear a
beep and the 24 hour timer is displayed. This establishes a starting time.
The unit will start at the prescribed time once only. This function must be
selected each time you want the vehicle to start. To activate this function,
(a) Turn the ignition switch off. (b) Within 10 seconds of step (a), depress
and hold the brake pedal, while pressing the key icon transmitter button 2
times. (c) the unit will emit 2 chirps, the transmitter will beep and the start
timer icon on the display will remain on. The vehicle will start at the set
time. To toggle this feature off, press the option + lock buttons simulta-
neously until a beep is heard and the 24 hour timer turns off.
NOTE:The unit will start once and run for the prescribed time. If you require
more frequent starting, please refer to auto start up timer mode
shown earlier in this guide.
NOTE: To insure accurate 24 Hour Start up, it is advisable to reset the start
time periodically as time may drift slightly each day.