Filter
Top Products
128-8794
15 of 24
Page 15
NOTE: The engine can be started in many modes
armed, disarmed, valet, etc... The screen shown is
Locked/Armed and running.
When the Panic Mode has been activated and the system is armed, the
vehicle's lights will flash, the siren and lock icon will be displayed on the LCD
screen and the siren will beep. If the system is disarmed and the Panic Mode
is activated, the lights will flash, the unlock icon will be displayed, and the siren
will beep on the LCD screen.
Whenever the vehicle is operated from the two way
transmitter, the unit will beep responsive to the function
executed at the vehicle: 1 beep when armed, 2 beeps when
disarmed, etc... At times it may be inconvenient or too noisy to
hear the beep tones, so the system allows you to set the unit
for vibrate mode. To toggle on or off beep tones/vibrate,
simultaneously press the "F" and unlock buttons. The icon
shown left will appear in the upper left hand corner of the
screen to indicate vibrate.
If the alarm system has been triggered, the icon displayed on the transmitter
LCD will indicate which zone has been activated, as well sound the beep
tones, or vibrate dependent upon the setting as shown above. The following
trigger patterns will be displayed:
Triggered and the entry attempt was made to one of the
vehicle Doors.
Triggered and entry attempt was made to the vehicle's Hood
or
Trunk.
Triggered and entry attempt was made to the vehicles glass, or
the vehicle has been hit or bumped hard enough to cause a
response from the vibration detector.