Audiovox PRO9246ft3 Automobile Alarm User Manual


 
-3-
CAR FINDER:
As an added convenience, your system has the ability to flash the parking lights, (If this
option has been added), on command from the transmitter. This feature is particularly
useful to help locate your vehicle in a crowded parking lot. To access this feature, simply
press and hold the Lock or Unlock button of your keychain transmitter for three seconds.
This mode will cancel automatically after 30 seconds, or you can cancel it from the
transmitter by pressing the same transmitter button again for three seconds. This mode
can also be canceled immediately, by pressing any button other than the lock or unlock
button.
VALET SWITCH
The valet switch allows you to temporarily bypass your system's security functions, eliminat-
ing the need to hand your transmitter to parking attendants or garage mechanics. When the
system is in valet mode, the starter inhibit feature, if installed, is bypassed, however the
remote door locks will remain operational. To use the valet mode, the system must first be
disarmed either by using your keychain transmitter, or by manually overriding the system.
1. Enter the vehicle, and turn the ignition key to the on position.
2. Press and hold the valet push-button switch until the dash mounted LED turns
on solid indicating that the valet mode has been entered successfully.
3. To return to normal operation, press and release the push-button switch any
time the ignition is on.
NOTE: Always remember to exit the valet mode to ensure that the vehicle remains
protected at all times.
MANUALLY OVERRIDING YOUR SYSTEM:
USING THE VALET SWITCH MANUAL OVERRIDE
Your Security System can be disarmed without the use of the keychain transmitter. This is
necessary, since you will need the ability to operate your vehicle if the transmitter is lost or its
battery fails. If your system has been selected for Valet Switch manual override as indicated
on the last page of this manual, to bypass the alarm system;
1. Open the vehicle door.
2. Turn the ignition key to the on position.
3. Within 5 seconds, press and release the valet push-button switch.
The system will enter the (bypassed) mode. You can now start and operate the vehicle
normally. Typically this override mode is used only if the transmitter has become inoperative.
Programming Your Custom Override Code:
Unlike override switches easily found, and defeated, this security system allows the
consumer to program a personal override code, offering a higher level of security. To take
advantage of this option, programmable feature # 6 must be selected for the Custom Code
Option. Consult your installation center for programming details. The system comes from