Filter
Top Products
128-6626
5 of 8
the manual override sequence. If the code is not successfully entered within the
three attempts, disarming with the manual override switch will be locked for 10
minutes.
In many cases, to increase the security of your system, you may elect to change
the manual override code to a number that is more familiar to you, or simply to
have a different code than was pre-assigned from the factory. To Change the pre-
assigned override code follow the steps outlined below.
It is advised you read both sections under the headings “Programming Your
Custom Override Code” and, “Custom Code Programming Example”, To com-
pletely understand the procedure before beginning:
Programming Your Custom Override Code:
Unlike override switches easily found, and defeated, the PRO-9232 allows the
consumer to program a personal override code, offering a higher level of security.
The system comes from the factory with a pre-programmed override code of 11. To
change this default override code, do the following:
1. Disarm the system by use of the transmitter, or by use of the emergency override
sequence. Turn the ignition switch to the on position.
2. Within 10 seconds, press and release the valet/override switch, 3 times.
3. Within 10 seconds turn the ignition switch off, on, off, on, off, on.
(The siren or horn will beep and the lights will flash one time.)
4. Within 10 seconds, begin to enter your chosen 10ths digit by pressing and
releasing the pushbutton switch from 1 up to 9 times.
5. Within 10 seconds of the last entered 10ths digit, turn the ignition switch off then on.
6. Within 10 seconds, begin to enter your chosen units digit by pressing and
releasing the pushbutton switch from 1 up to 9 times.
7. Finish by turning the ignition switch to the off position.
If the new code was accepted, the unit will report back the newly entered code, by
flashing the LED, first indicating the 10ths digit, pause and then the units digit.
The unit will report the new code three times with a one second pause between
each code, then the system will begin arming. If the LED flash pattern re-
ports the previously stored code, the new code was not entered correctly. Please
repeat steps 1 through 7 above considering the following.
NOTE: Acceptable digits 10ths or units are 1 through 9. The unit will not recognize
a0 (Zero), or no digit entered in any place, units or tenths.
NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for
more then 5 seconds during any of the above steps, the unit will revert back
to the last successfully stored code.
Page 5