Filter
Top Products
128-6846
4 of 4
The Option Button: Press nd release the OPT Button on the transmitter and the unit,
providing it is within range of the device it is controling, will operate the device. This
option button can be programmed into a number of Audiovox accessories. If the accessory
is a second two way Audiovox Remote Start Unit, perhaps installed in a second vehicle,
then the vehicle will act upon the command but only the prime transmitter for that vehicle
will indicate the command was acted upon.
Toggling Between Vibrate, Chirp, or Both Chirp & Vibrate:
The two way transmitter offers the option of having Beep Tones, Vibration, or Both Beep
Tones & Vibration associated with the function responses of the transmitter.
To toggle between these modes, press simultaneously the "F" function button and the
Unlock Icon Button. The transmitter will beep, beep & vibrate, or vibrate only toggeling on
the specific preference.
Check Vehicle Status:
Press the lock+key+option buttons simultaneously for 1 second. The vehicle's alarm will
display the systems current status breifly by flashing the LED associated with the state the
vehicle was left in. This feature is useful if you do not want to wait the 10 seconds for a LED
to display the status or if you just want to check the status without operating the Lock or
Unlock buttons.
SAFETY CONTROL SWITCH
The red handle control switch allows you to temporarily disable the remote starting function of
the system and moving this switch to the Off position is recommended whenever the vehicle is
being serviced. When the system is disabled, the remote door locks and optional accessories
will remain operational.
FUNCTION SETTING CHART
To be completed by installer
Run Time 5 Min o 10 Min o 15 Min o 20 Min o
Door Lock Timer 1 Sec/1 Sec o 3.5 o 1 Sec/Dbl 1 Sec o
Lights Pulse o Steady o
Option Button Programmed To Control _________________________
© 2003 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788
128-6846
4