Filter
Top Products
128-6846
3 of 4
The Lock LED Indicates:
When the lock button on the transmitter is pressed and the command is received and
acted upon by the unit in the vehicle, this LED will light Red and the transmitter will beep
once, then will continue flash once every 10 seconds so you, at a glance, can determine the
status of your vehicle or determine the state it was last left in.
The Unlock LED Indicates:
When the unlock button on the transmitter is pressed and the command is received and
acted upon by the unit in the vehicle, this LED will light Red and the transmitter will beep
twice, then will continue flash once every 10 seconds so you, at a glance, can determine the
status of your vehicle or determine the state it was last left in.
The Key LED Indicates:
When the key transmitter button is operated two times in succession and the start
command is received and acted upon by the unit in the vehicle, this LED will light Red and
the transmitter will play the remote start melody indicating that the vehicle is running and
will continue to run for the preset period as determined at time of installation. If you wish to
prematurely shut down the remote start while the vehicle is still running, simply press the key
transmitter button two times in succession.
The vehicle will turn off and the Not Key LED will turn on breifly.
The Not Key LED Indicates:
Whenever the remote start turns off, either by intentional activation on the part of the
operator, or by timing out after the preset run timer, this Not Key LED will light Red breifly
and the transmitter will play the shut down melody.
NOTE: If the vehicle is under the control of the Remote Start and the vehicle is running,
when either Lock or Unlock button is pressed, the Lock or Unlock LED, and the Start LED will
turn on momentarily.
Two Way Transmitter Operation:
The two way transmitter shown earlier in this manual operates similar to any transmitter with
the exception that it will also indicate that the vehicle acted upon the command issued.
Locking: Press and release the Lock Icon Button on the transmitter and the unit, providing it
is within range of the vehicle, will lock the vehicle doors and report back that the command
was acted upon by breifly turning on the Lock LED and beeping once. This lock LED will
flash 1 time every 10 seconds until the Unlock command is issued.
Press and hold for lock button for three seconds causes the unit to go into the car finder
mode. See car finder reference shown earlier in this manual.
Unlocking: Press and release the Unlock Icon Button on the transmitter and the unit,
providing it is within range of the vehicle, will unlock the vehicle doors and report back that
the command was acted upon by breifly turning on the Unlock LED and beeping twice. This
unlock LED will flash 1 time every 10 seconds until the lock command is issued.
Press and hold for unlock button for three seconds causes the unit to go into the car finder
mode. See car finder reference shown earlier in this manual.
Starting The Vehicle: Press and release two times in succession the Key Icon Button on the
transmitter and the unit, providing it is within range of the vehicle, will Start the vehicle and
report back that the command was acted upon by flashing 5 times the Key LED and playing
the start melody. Operating the lock button or unlock button while the unit is under the
control of the remote start will cause the lock or unlock LED to light breifly, the transmitter
will chirp once for lock or twice for unlock, and along with that, the Key LED will turn on for 4
seconds indicating the vehicle is still running under command of the remote start unit.
3