Audiovox AS 9075 Automobile Alarm User Manual


  Open as PDF
of 3
 
NOTE: The engine will stop running before the expiration of the pre-programmed run timer
if you complete any of the following:
1. Pressing the proper button or buttons of your keychain transmitter while running under
control of the remote start system will turn the vehicle off.
2 . Depress the brake pedal.
3. Open the hood.
4. Move the red handled control switch to the off position.
5. Race the engine to above 4000 RPM.
OPERATING ON AUT OMATIC START UP TIMER MODE
The AS-9075 has the ability to automatically start the vehicle every 2 or 4 hours over a 48
hour period. This feature is especially useful in cold climates where the only means to
keep the engine and engine fluids warm is to periodically start the engine.
CAUTION! Be certain that the vehicle is outdoors before using this or any remote vehicle
starting device. A running engine produces dangerous carbon monoxide
fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT
remote start the vehicle if the car is garaged.
TO BEGIN THE AUTOMA TIC START UP TIMER
1. Turn the ignition key on then off.
2 . Within 10 seconds, activate the RF start command two times.
The parking lights will flash 4 times indicating the timed start mode is activated.
The vehicle, ona2or4hour interval basis, will automatically start, run for the
pre-programmed time (10 of 15 minutes), and thenshut off. This willcontinuefor 48 hours.
NOTE: The automatic start up timer can also be initiated from the keychain transmitter .
To do this:
1 . Start the vehicle using the keychain transmitter by pressing and releasing the remote
start transmitter button'(s).
2. Shut off the vehicle using the keychain transmitter by pressing and releasing the remote
start transmitter button'(s).
3. Within 10 seconds of step 2, activate the RF start command two times.
The parking lights will flash 4 times indicating the timed start mode is activated.
CANCELING THE AUT OMATIC START UP TIMER
To cancel the automatic start up timer do one of the following;
1. Start the vehicle manually with the use of the ignition key and depress the brake pedal.
2 . Remote start the vehicle using your keychain RF transmitter.
And then
3 . Shut off the vehicle using the keychain RF transmitter.
Page 3
FUNCTION SETTING CHART
To be completed by installer
Lights Steady Pulse
Run Time 10 Min. 15 Min.
150 Marcus Blvd., Hauppauge NY 11788 (516) 231-7750
128-5364
 previous