Filter
Top Products
Page 2
The AS-9075 Remote Start Upgrade unit is designed to be added to an existing remote
control keyless entry system, or remote alarm system.
Because it is an upgrade unit it can be wired to operate from any unused button(s) from
your keychain transmitter. Please check with your inst alling dealer for which transmitter
button is connected to your remote start unit and, if you require a single, double, or
sequential press of the button(s) to operate your AS-9075.
SAFETY (Red Handled ) CONTROL SWITCH
The control switch allows you to temporarily disable the remote starting function of your
AS-9075. To disable the unit, move the red handled control switch to the off position.
The control switch also allows you to select between automatic 2 hour start up or 4 hour
start up when using the automatic start up timer mode. The factory preset start up time for
this mode is every 4 hours. To select between 2 or 4 hour start up timer:
1. Begin with the control switch in the on position
2. Turn the ignition switch on then off
3. Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to select
a 2 hour start timer. After 10 seconds expire, the parking lights will flash 2 times
confirming that the two hour start cycle is set. Or, within 10 seconds move the control
switch off, on, off, on, off, on, off, on (4 switch cycles) to select a 4 hour start timer.
The parking lights will flash 4 times confirming that the 4 hour start timer is set.
REMOTE STARTING THE VEHICLE
The AS-9075 WILL NOT start the vehicle if any one of the following conditions exists:
1. The Vehicle Hood Is Opened.
2 . The Gear Selector Is In Any Gear Other Then Park.
3. The Brake Is Depressed.
4 . The Safety Control Switch Is In The Off Position.
CAUTION! Be certain that the vehicle is outdoors before using this or any remote vehicle
starting device. A running engine produces dangerous carbon monoxide fumes
which can be harmful or fatal if prolonged exposure occurs. DO NOT remote
start the vehicle if the car is garaged.
To Remote Start The V ehicle:
Press and release the proper button or combination of buttons on your keychain transmitter
to activate the remote start system. The vehicle will start and remain running for the
pre-programmed 10 or 15 minutes. As a visual indication, the parking lights will flash or
turn on dependent on the programming set up by your installation center.
When you arrive at your vehicle, unlock the vehicle by pressing and releasing the unlock
button of your keychain transmitter or by use of the vehicle key. Enter the vehicle and turn
the ignition key to the on position.
CAUTION! Do not turn the key to the start position. This will cause the startermotor to engage
with the already running engine which could result in damage. Step on the brake
pedal to disengage the remote start unit. The vehicle will continue to run on it's
own power .