Filter
Top Products
Page 3
WIRING
THIN RED WIRE FROM FLASHING LED LIGHT: (12 Volts Positive Input)
This wire supplies a constant positve 12 volts to operate the LED. The connection should be
made to a location that has a constant positive 12 volts at all times.
BLACK WIRE FROM VALET TOGGLE SWITCH: (Ground Input)
This wire provides a path to ground for all the circuits on AS-9950. This wire should be secured
to the metal ground frame of vehicle or directly to the battery ground terminal.
Make sure to
scrape away all dirt and grease to get good ground connection.
YELLOW WIRE FROM AS-9950: (Ignition 12 Volt Input)
When the ignition key is in the “off” position, the starter interrupt function is enabled preventing
the vehicle from being started again. When ignition key is in the “on” position, applying 12 volts
to the secret switch circuit will disable starter interrupt function. This will allow the vehicle to
be started. Connect this wire to an ignition wire in the car which has 12 volts in the on and crank
positions of the ignition key and 0 volts when the key is off.
PINK WIRE FROM AS-9950: (To Secret Override Switch)
When the ignition key is in the “on” position, momentarily applying positive 12 volts to this wire
will override the starter interrupt function allowing the vehicle to be started. Once the ignition
key is turned to the “off” position, the starter interrupt function will automatically be enabled,
preventing the vehicle from being started. This wire can be connected in two manners. Refer
to option A or B.
A) Connect this wire to any on/off switch that when in the “on” position, positive 12 volts
is applied. Some examples are the brake light switch, parking light switch, positive type
doorlock switch, window roll up switch, turn signal switch, etc. Using an existing switch
eliminates the need to install another switch in the vehicle.
B) Connect this wire to any additionally installed momentary pushbutton switch that when
in the “on” position, supplies positive 12 volts.
SECRET OVERRIDE
SWITCH
PINK OVERRIDE WIRE +12V