Filter
Top Products
These factory programmed settings can be prioritized based on an individual's frequency of
use, (i.e. pressing both buttons simultaneously to activate channel 1, arm/disarm etc.) by
following the normal programming instructions below.
Please note when changing the button sequences of the factory settings, it is necessary to
perform steps 5, 9, and 12 three times using "transmitter A", followed by one time using
"transmitter B".
1. Enter the vehicle, and turn the ignition key to the "on" position.
2. Move the valet/bypass switch on - off - on - off - on then off.
3. The dash L.E.D. will flash one time, and the siren will "chirp" one time, indicating the
system is ready to accept programming for channel 1, or the arm/disarm and panic
functions.
4. You can assign any of the three transmitter button functions listed below to channel 1.
a) Pressing button #1 on the keychain transmitter.
b) Pressing button #2 on the keychain transmitter.
c) Pressing both buttons simultaneously on the keychain transmitter.
5. Press and hold the selected choice a, b, or c above, until the siren emits a long "chirp" to
confirm that programming of channel 1 was successful.
TO PROGRAM ADDITIONAL TRANSMITTERS:
It is important to remember that during programming, each individual step of the procedure
must be executed within 15 seconds of the previous step. When the 15 second time limit is
allowed to expire, the system will automatically exit program mode. This is indicated by a
long "chirp" from the siren.
Additionally, any time the ignition key is turned off while programming, the system will
immediately exit program mode. This is also indicated by a long "chirp" from the siren.
PROGRAMMING TRANSMITTERS: