Filter
Top Products
Page 3
DISARMING THE SYSTEM (CHANNEL 1) :
1. As you approach the vehicle, press and release the ARMING button on the
keychain transmitter.
WARNING! Excessive pressure on the transmitter buttons will damage the
internal components on the circuit board. All that is required is a light push to
the button.
2. The siren will "chirp" 2 times, the vehicle's parking lamps will flash two times
and the doors will unlock indicating the system is DISARMED.
3A. ACTIVE : The dash mounted L.E.D. will turn off, and remain off until the system
is re-armed.
3B. PASSIVE : Never attempt to disarm the system from a distance that prevents
you from opening a door within 30 seconds. Since the system is programmed
for pasivearming,it will beginto re-arm untila door isopened. Opening the door
will suspend the passive arming cycle.
INTRUSION WARNING SIGNALS:
The system will inform you if an intrusion attempt has occurred while you were away
from the vehicle. If an intrusion attempt has occurred, the siren will "chirp" 4 times
when disarming the system.
The vehicle's parking lights will also flash 3 times to indicate an intrusion has
occurred. Enter the vehicle and observe the dash mounted L.E.D. for further
information.
1. If the L.E.D. is flashing two times...pause...two times...etc., then an intrusion
attempt was made to the hood, trunk, or an optional sensor.
2. If the L.E.D. is flashing three times...pause...three times...etc., then an intrusion
attempt was made through one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory, and will only
be erased from memory when the ignition key is turned on.
VALET / SYSTEM OVERRIDE SWITCH:
The "Valet" switch allows you to temporarily bypass all alarm functions, eliminating
the need tohand your transmitterto parking attendants orgarage mechanics. When
the system is in valet mode, all alarm functions are bypassed, however, the remote
panic feature and remote door locks will remain operational. To use the valet mode;
1. Enter the vehicle and turn the ignition key to the "on" position.
2. Move the valet toggle switch to the "on" position. The dash mounted L.E.D. will
turn on solid, and remain on as long as the system is in the valet mode.
3. To return to normal operation,move the valet switch to the "off" position any time
the ignition is on.
In the event you lose your keychain transmitter, or if the transmitter fails to disarm
the system, the valet switch can be used as a system override switch. Open the car
door (the alarm will sound). Turn the ignition key on, and move the valet switch to
the "on" position. The alarm will stop sounding, and the vehicle can now be started.
NOTE: Always remember to move the Valet Switch back to the "off" position. This
will ensure that the vehicle remains protected at all times.