Filter
Top Products
Page 4
SILENTDISARMING
1. As you approach the vehicle, press and hold the ARM / DISARM button on the keychain
transmitter for 2 seconds.
Red dash mounted L.E.D. turns off.
If passive arming was selected during the installation, then the L.E.D.
will start flashing rapidly, indicating that the system is re arming auto-
matically. Open any door to suspend the automatic arming.
Parking Lights flash two times.
If the parking lights flashed three times,then the alarm was triggered in
your absence. Before turning the key on, examine the L.E.D. toidentify
which zone was triggered.
Siren / Horn does not sound.
If the siren and or horn sounds 4 chirps, then the alarm was triggered
in your absence. Before turning the key on, examine the L.E.D. and
refer to the INTRUSION WARNINGSIGNALS section of this manual to
identify which zone was triggered.
Doors Unlock.
Using the optional ACCESSGUARD feature, the alarm canbe wired to
unlock only the driver’s door during this step. To unlock all doors, press
and release theARM / DISARMbutton a secondtime within 5 seconds.
Courtesy lights turn on for 30 seconds, or until the ignition key is switched on.
INTRUSIONW ARNINGSIGNALS
This system will inform you if an intrusion attempt has occurred while you were away from
the vehicle. If an intrusion attempt has occurred, the siren/horn will chirp 4 times and the
parking lights will flash 3 times when disarming the system. Enter the vehicle, and observe
the red dash mounted L.E.D. to identify which zone was triggered.
If theL.E.D. isflashing onetime...pause...one time...pause...etc.,then anintrusion
attempt was made to the shock sensor, or an accessory triggering device that
may have been added to the system.
If the L.E.D. is flashing two times...pause...two times...pause...etc., then an
intrusion attempt was made to a hood or trunk pin switch that was added to the
system, or to a light activated entry point if the alarm was installed using the
voltage sensing feature.
If the L.E.D. is flashing three times...pause...three times...pause...etc., then an
intrusion attempt was made through one of the vehicle’s doors.
These intrusion warning indicators are stored in the system’s memory, and will only be
erased when the ignition key is turned on.