Menu

Audiovox APS-350-A Automobile Alarm User Manual

of 7
Page 1
Model APS-350-A
Installation Manual
SELECTABLE FEATURES
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch in order
to begin the passive arming sequence.
RF Programmable Features :
Feature Selection 1 Chirp 2 Chirps Default
First 1 Second Door Locks 3.5 Second Door Locks 1 Second
Second Auto Lock On Auto Lock Off Auto Lock Off
Third Auto Unlock On Auto Unlock Off Auto Unlock Off
Fourth Passive Door Locks Active Door Locks Active Locks
Fifth Passive Arm Active Arm Passive Arm
Sixth Voltage Sense Hardwire Hardwire On
Seventh Horn Chirps On Horn Chirps Off Horn Chirps On
Eighth Siren Chirps On Siren Chirps Off Siren Chirps On
To program these selectable features;
Action System Response LED Response
Turn ignition on No response
Flip valet switch on then off 3 times 1 Chirp - LED 1 flash
Within 3 seconds, turn ignition Off Short chirp, then long chirp
First Within 3 seconds, turn ignition On 1 chirp = 1 second door locks 1 Flash Pause...
Press transmitter button 1 to change 2 chirps = 3.5 second door locks
or
Second Flip valet switch on then off 2 chirps = auto locks off 2 Flash Pause...
Press tranmitter button 1 to change 1 chirp = auto locks on
or
Third Flip valet switch on then off 2 chirps = auto unlock off 3 Flash Pause...
Press transmitter button 1 to change 1 chirp = auto unlock on
or
Fourth Flip valet switch on then off 1 chirp = passive locks 4 Flash Pause...
Press transmitter button 1 to change 2 chirps = active locks
or
Fifth Flip valet switch on then off 1 chirp = Passive Arm 5 Flash Pause...
Press transmitter button 1 to change 2 chirps = Active Arm
or
Sixth Flip valet switch on then off 1 chirp = Voltage sense on 6 Flash Pause...
Press transmitter button 1 to change 2 chirps = Hardwire
or
Seventh Flip valet switch on then off 1 chirp = Horn chirps on 7 Flash Pause...
Press transmitter button 1 to change 2 chirps = Horn chirps off
or
Eighth Flip Valet Switch on then off 1 chirp = Siren chirps on 8 Flash Pause...
Press transmitter button 1 to change 2 chirps = Siren chirps off
or
Flip valet switch on then off Exit program mode
or
Turn ignition key off Exit program mode
Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the
programming will be terminated.
next

Additional Audiovox APS-350-A Automobile Alarm Literature



Audiovox APS-350-A Automobile Alarm Discussions


Need help with this product?


Related Audiovox Products

  • 5BCR03 - Audiovox Remote Start Security System Programming Guide
  • AA-929 - Audiovox Two Wire Alarm Security System Installation Guide & Owner's Manual
  • AA-930 - Audiovox Electronics Corp. Remote Alarm With Shock Sensor Installation & Operation Manual
  • AA-9300 - Audiovox Automobile Alarm User Manual
  • AA-931 - Audiovox Model AA-931 Active Remote Control Auto Security System Owner's Manual
  • AA-940 - Audiovox Two Button Code Learning Remote Alarm Installation & Operating Manual
  • AA-RS40CS - Audiovox 4 Channel Remote Car Starter Installation Manual
  • AA925 - Audiovox Car Alarm Installation Manual
  • APS 33 - Audiovox 2 Button Remote Security System With Anti-Hijack Feature Owners Manual
  • APS 500 - Audiovox Car Security System Installation Manual
  • APS 600 - Audiovox Prestige Platinum Installation Manual
  • APS 95 BT3S - Audiovox Transmitter Programming Guide
  • APS-155 - Adiovox Arming and Voltage Sensing Installation Manual
  • APS-15CH - Audiovox Electronic Corporation Owner's Manual Remote Security System APS-15CH
  • APS-15CL - Audiovox Remote Control Auto Security System Installation Manual
  • APS-15R - Audiovox Remote Control Auto Security System Installation Manual
  • APS-255CH - Audiovox OWNERS MANUAL Car Alarm APS-255CH
  • APS-25C - Audiovox Automobile Alarm User Manual
  • APS-2K4MS - Audiovox Car Security System Programming Guide






TRUSTe Seal


  • Facebook
  • Twitter
  • ManualsOnline Blog
  • ManualsOnline Google Plus