Audiovox APS-20B Automobile Alarm User Manual


 
Page 5
This will cause the lights to flash, the siren to sound. The panic mode will continue for 30
seconds and then reset.
To disengage the panic feature before the 30 seconds are up, press and hold the lock or
unlock button of your keychain transmitter for 3 seconds.
While the panic mode is engaged, the doors can be remotely locked and unlocked via the
transmitter by pressing the lock or unlock button momentarily.
ADDITIONAL REMOTE FUNCTION CHANNEL 2
The system has an additional feature, (Channel 2) , that can be connected to a number of
different optional accessories. Some of the more common uses for this channel are:
! Remote Trunk Release
! Remote Window Close
! Remote Garage Door Interface
To operate the accessory associated with Channel 2,
press and
hold
the option button of
your keychain transmitter for three seconds.
NOTE: You may access the Channel 2 command regardless of whether the system is "armed"
or "disarmed", but not when the ignition switch is in the on position. This is to prevent the
output from accidentally opening the vehicle's trunk when the vehicle is in motion.
IGNITION DOOR LOCKING/UNLOCKING
When connected to a vehicle's power door lock system the unit is capable of being pro-
grammed for the added safety and security of ignition controlled door locking and unlocking.
These features are separate, so the unit may be programmed for one, or both, or neither.
These features can only be used if the optional door lock/unlock circuit is installed.
When the ignition door locking feature is programmed, the system will cause all door locks to
lock whenever the ignition switch is turned from the "off" to "on" position, (providing that all
doors are closed at that time). All doors will lock approximately 2 seconds after the vehicle's
ignition switch is turned on. This is a nice feature for maintaining the personal safety of the
occupants of the vehicle, in an effortless and automatic manner.
When the ignition door unlocking feature is programmed, system will cause all door locks to
unlock whenever the ignition switch is turned from the "on" to "off" position. All doors will
unlock immediately after the vehicle's ignition switch is turned off.
As stated these features are programmed separately, so you may chose to use one, both,
or neither. Please consult with your dealer to consider your options.