Filter
Top Products
Page 3
detector to trigger the alarm when armed. If the
optional
2-stage shock sensor is installed,
any lesser impact will cause the pre-detect stage of the shock sensor to emit a series of short
warning tones from the siren when armed.
If the optional starter interrupt is installed the vehicle starter circuit is disabled, even with the
ignition key the vehicle will not start.
DISARMING THE SYSTEM
As you approach the vehicle, press and release the unlock button on the keychain transmit-
ter.
The parking lights will flash two times, the siren will chirp twice and the dash mounted LED will
turn off. If you have the optional door lock/unlock circuit installed, the doors will unlock.
Note: If the passive arming mode was selected at the time of installation, the dash mounted
LED will start flashing rapidly indicating that the system is rearming. Opening any door will
suspend the automatic arming.
If the parking lights flashed three times and the siren chirps four times, this indicates that the
alarm system had been triggered in your absence. Before turning on the ignition key, examine
the dash mounted LED's flash pattern. The number of flashes identifies the triggered zone.
For additional information, refer to INTRUSION WARNING SIGNALS found later in this manual.
If the siren did not sound upon disarm, then the chirps have been turned off. Refer to the
section titled ELIMINATING THE ARM/DISARM CHIRPS.
SILENT DISARMING
1. As you approach the vehicle, press and hold the unlock button of your key chain transmitter
for two seconds, or until the system responds.
The parking lights will flash twice and the dash mounted LED will turn off, confirming that the
system is disarmed. The siren will not chirp. If you have the optional door lock/unlock circuit
installed, the doors will unlock.
Note: If the passive arming mode was selected at time of installation, the dash mounted LED
will start flashing rapidly indicating that the system is rearming. Opening any door will
suspend the automatic arming.
If the parking lights flashed three times and the siren chirps four times, this indicates that the
alarm system had been triggered in your absence.
VALET/PROGRAM/MANUAL OVERRIDE SWITCH
The valet switch allows you to temporarily prevent the alarm from arming, eliminating the need
to hand your keychain transmitter to parking attendants or garage mechanics. When the
system is in the valet mode, all alarm functions are by-passed, however the remote panic
feature, and the optional remote door lock/unlock will remain operational.
To enter the valet mode:
1. Start with the valet switch in the "off" position
2. Turn the ignition switch to the "on" position.
3. Within 10 seconds of step 2, flip the valet switch to the "on" position.
The dash mounted LED will turn on solid indicating that the valet mode has successfully been
entered.