Audiovox APS-101 Automobile Alarm User Manual


 
128-8253
5 of 8
Page 5
REMOTE PANIC OPERATION
The Lock/Arm / Unlock/Disarm button on your keychain transmitter also functions as a panic
switch for use in emergency situations. To use remote panic,
1. Press and hold this button on the keychain transmitter for 3 or more seconds. The
alarm will immediately sound.
2. To stop the alarm, press and hold the button on the transmitter again for 3 seconds.
If the button is not pressed, the alarm will automatically stop after 30 seconds.
NOTE: Pressing the Trunk button of the transmitter while in the panic mode will cause
the siren to immediately stop sounding.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 2 )
This security system has an additional feature that can be connected to a number of different
optional accessories. Some of the more common uses for this channel are;
Remote Trunk Release
Remote Car Starter
Remote Window Closure
To activate the optional accessory, press and hold the Trunk/Key button on the keychain
transmitter for two seconds.
Car Locator:
Anytime during the armed mode, if the Trunk/Key button is pressed within range of the
vehicle, the siren will chirp 6 times and the parking lights will flash 12 times allowing easy
location of the vehicle in a crowded parking light.
Transmitters Included With This Kit:
The transmitters are programmable and at times it may become necessary to replace trans-
mitters if they become broken or if they are stolen. If this is the case, order replacement
transmitters from Audiovox Customer Service @ 1800-645-4994. The transmitters pack-
aged with this kit are 101TX.
To Program new or replacement transmitters:
1. Enter the vehicle, and turn the ignition key to the “on” position.
2. Press and release the valet/override/program push button switch 3 times.
3. The dash LED will flash one time and the siren will “chirp” 1 time indicating the
system is ready to accept programming for channel 1 Lock/Arm / Unlock/Disarm
and Panic.
4. Press and hold the lock/unlock button of the first transmitter until the parking lights
flash and a long chirp is heard from the siren
Repeat for each transmitter to be programmed. Note a maximum of 4 transmitters can be
programmed.
Turn the ignition switch off or allow 15 seconds of inactivity to exit the transmitter program
mode.
By completing the above, both buttons of the transmitters are programmed into their default
location.
Lock/Unlock = Lock / Arm / Unlock / Disarm & Panic On & Off
Trunk = Trunk Release, Panic Cancel, & Car Finder. Press & Hold 2.5 seconds to
release trunk, Press while Panic Sounding to cancel panic immediately.
Car finder anytime during the armed mode.
On-Board Shock Sensor Setting:
1. Enter the vehicle, and turn the ignition key to the “on” position.
2. Press and release the valet/override/program push button switch 3 times. Siren
Chirps Once & Led Flash Once
3. Turn the ignition off than on, you will hear short chirp followed by long chirp.
4. Turn the ignition off then on, you will hear two long chirps indicating that you are in the
shock adjust mode.