Filter
Top Products
128-8253
6 of 8
Page 6
5. Press the lock/unlock button to increase, and the trunk button to decrease. The siren
will chirp 1-14 times 1 being lowest and 14 being highest. Firmly strike the bumper of
the vehicle during the setting until you find the desired setting for the Full Trigger Stage.
6. Press both the lock/unlock & trunk buttons of the transmitter simultaneously until the
siren emits two long siren chirps indicating that you are in the Pre-Detect stage.
7. Press the lock button to increase, and the trunk button to decrease. The siren will chirp
1-14 times 1 being lowest and 14 being highest. Firmly strike the bumper of the vehicle
during the setting until you find the desired setting for the Pre-Detect Stage.
Once you have achieved the desired setting, either turn the ignition off or allow 60 sec-
onds of inactivity to expire to exit the Shock Adjust Mode. Exit of the shock adjust mode is
indicated by the siren emitting 3 long chirps.
CAUTION: Never perform this test on the vehicle’s glass, as you may break the
window.
WARNING ! Setting the sensitivity too high can cause false alarms due to noise vibrations
from passing trucks and heavy equipment. To decrease sensitivity, follow steps 1-5 above
and use the trunk button to decrease.
Battery Replacement:
Use CR2032 or equivalent.
1) Using a 0 Point Phillips Screwdriver, remove the screw from the back of the case
where indicated by the arrow.
2) Carefully separate the top case from the bottom.
3) Slide the discharged battery from under the clip
in the direction shown.
4) Properly dispose of the discharged battery.
5) Replace with a new CR2032 or equivalent bat-
tery.
6) Carefully align and snap closed the transmitter
case.
7) Reinstall the screw removed in step #1.