Filter
Top Products
10
1. RF Programmable Features:
Feature Selection 1 Flash 2 Flash 3 Flash 4 Flash Default
1 Run Time 5 Min. 10 Min. 15 Min. 20 Min. 10 Min.
2 Ign. 2 During Crank Off On On
3 Light Output During Run Steady Flash Steady
4 Tach Mode NA Tach Tach
5 NA NA NA NA NA NA
6 Trouble Shooting Off On Off
7 Door Locks 1 Sec/1 Sec 3.5 Sec/3.5 Sec 1 Sec/Dbl 1 Sec 1 Sec/1 Sec
To program these selectable features:
1. Start with the programming switch in the OFF position.
2. Turn the ignition key to the ON position.
3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.
4. Immediately turn the ignition key OFF, then back to ON.
5. Flip the program switch ON - OFF - ON - then OFF.
6. Use button 2 on the transmitter to advance to the feature that you want to change. EXAMPLE - If you need to change
programmable feature number 3, press and release button 2 on the transmitter 3 times in succession. The parking
lights will flash 3 times confirming that selected feature 3 can now be programmed.
7. Use button 1 on the transmitter to change the selection of the programmable feature. If you are not sure what the setting
for any feature is, press button 1 one time, the parking lights will flash once or twice indicating the features setting.
Note: Once you enter the feature programming mode, do not allow more that 15 seconds to pass between steps, or the
programming will be terminated.
2. Programming Tach Rate:
NOTE: All applications require that tach be programmed.
The unit will not operate unless tach is programmed. If an attempt is made to start the vehicle via the remote start without
first programming tach, the unit will flash the parking lights 7 times indicating tach has not been learned and stored. If
the tach rate is not properly programmed to the specific vehicle, the unit may not realize that the vehicle is running in
certain instances re-engage the starter motor.
The Remote Car Starter will learn the tach rate of most vehicle's single ignition coils, multiple coil packs, and or single
injector. To learn tach;
1. Start with the programming switch in the OFF position.
2. Turn the ignition key to the ON position.
3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.
4. Immediately turn the ignition key OFF.
5. Flip the program switch ON, then start the vehicle using the ignition key.
6. When the unit senses the tach signal, the parking lights will begin to flash.
7. Flip the program switch OFF. The parking lights will turn on for 3 seconds to indicate that the tach signal is stored
and the unit is now out of the program mode.
3. Diagnostics:
1. Be sure that programmable feature number #6 is set to the "Diagnostics On" mode.
2. First flip the program switch on, then turn the ignition key to the ON position.
3. The lights will flash and the number of flashes will indicate the reason for shutdown on the last remote start attempt.
The indications are as follows.
1 Flash 5, 10, 15, or 20, minute run timer expired
2 Flashes Low or no tach signal received.
3 Flashes Positive or negative input shut down.
4 Flashes Control switch was moved to off position
5 Flashes RF Shutdown command received.
6 Flashes High RPM signal overspeed shut down
7 Flashes Tach has not been learned.