Filter
Top Products
12
NOTE:
1. When selecting Diesel operation, (Feature Nine), over gasoline, the only change is to the ignition circuits. When
Diesel is selected, the ignition circuits will power up 10 seconds before the start circuit. The intent of this feature is to
allow the glow plug warming required by some diesel engines. If your vehicle is a instant start diesel, it is not
necessary to activate this feature.
NOTE: When selecting Diesel mode, be certain that the intended vehicle has a true tach reference and be certain to
connect the tach input wire.
2. The difference between selecting Starter Pole 5X or Starter Pole 3X, (Feature Ten), is considering the time it takes
from when the unit reaches the pre-set RPM to when the Starter Motor drops out. This feature allows fine adjust-
ments when you note a slight overcrank. If after programming tach, the unit seems to hold the starter engaged slightly
longer than necessary, select this feature to pole 3 X. If the unit starts and the starter drops out properly, (NO
OVERCRANK) no change is necessary.
To program these selectable features:
1. Start with the programming switch in the OFF position.
2. Turn the ignition key to the ON position.
3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.
4. Immediately turn the ignition key OFF, then back to ON.
5. Flip the program switch ON - OFF - ON - then OFF.
6. Use button 1 on the transmitter to advance to the feature that you want to change. EXAMPLE - If you need to change
programmable feature number 3, press and release button 1 on the transmitter 3 times in succession. The parking
lights will flash 3 times confirming that selected feature 3 can now be programmed.
7. Use button 2 on the transmitter to change the selection of the programmable feature. If you are not sure what the
setting for any feature is, press button 2 one time, the parking lights will flash once or twice indicating the features
setting.
Note: Once you enter the feature programming mode, do not allow more that 15 seconds to pass between steps, or
the programming will be terminated.
2. Programming Tach Rate:
NOTE: All applications require that tach be programmed.
The unit will not operate unless tach is programmed. If an attempt is made to start the vehicle via the remote start without
first programming tach, the unit will flash the parking lights 7 times indicating tach has not been learned and stored.
If the tach rate is not properly programmed to the specific vehicle, the unit may not realize that the vehicle is running
in certain instances reengage the starter motor.
The Remote Car Starter will learn the tach rate of most vehicle's single ignition coils, multiple coil packs, and or single
injector. To learn tach;
1. Start with the programming switch in the OFF position.
2. Turn the ignition key to the ON position.
3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.
4. Immediately turn the ignition key OFF.
5. Flip the program switch ON, then start the vehicle using the ignition key.
6. When the unit senses the tach signal, the parking lights will begin to flash. The lights must flash at least 10 times
7. Flip the program switch OFF. The parking lights will turn on for 3 seconds to indicate that the tach signal is stored
and the unit is now out of the program mode.
3. Diagnostics:
1. Be sure that programmable feature number #7 is set to the "Diagnostics On" mode.
2. First flip the program switch on, then turn the ignition key to the ON position.
3. The lights will flash, and number of flashes will indicate the reason for premature shutdown of the last remote start.
The indications are as follows: