Audiovox AA-939 Automobile Alarm User Manual


 
-3-
B. Pass the switch through the hole from
behind the panel, and secure from the front
using the split lockwasher and hex nut
provided.
Mounting the Starter Interrupt Relay
The relay will be mounted in the passenger’s
compartment. Mount the relay close to the
wires from the ignition switch.
To mount the relay;
A. Screw the relay to the mounting surface,
using a sheet metal screw through the
hole in the relay mounting tab.
B.Secure the relay to an existing wire harness
or other component using cable ties.
WIRING THE SYSTEM
Making the connections to the vehicle, as
described in this wiring section, may be
beyond the technical abilities of the average
consumer. If you have any questions with the
wiring procedures, please call a qualified
automotive technician, or call the AUDIOVOX
HOT LINE at 1-800-225-6074. Prior to making
any connections, a 12 Volt logic probe should
be used to confirm the proper connection point.
IMPORTANT ! The 9 pin white connector on
the end of the main harness that plugs into the
siren control module should remain disconnected
during the wiring portion of the installation.
Leaving this disconnected will ensure that the
keychain transmitters are properly programmed
later in the installation.
Routing The Wiring Harness
The GRAY, ORANGE, and YELLOW wires
must be routed through the firewall and into the
passenger compartment of the vehicle. The
ORANGE wire should be routed toward the
Starter Interrupt Relay harness. The GRAY
wire will be routed to the override switch. The
SHEET METAL
SCREWS
RELAY
MOUNT INSIDE
PASSENGER'S
COMPARTMENT
RELAY
WIRE TIE TO EXISTING
HARNESS IN VEHICLE
TOGGLE SWITCH
HEX NUT
SPLIT LOCKWASHER
DRILL A 1/4" DIAMETER HOLE