Filter
Top Products
128-6690
3 of 8
NOTE: If the program switch is operated again, the circuit will recycle
through the program mode. In other words, press 1 time to access the lock
function, 2 times to access the unlock function, 3 times to access the start
function. When programming is complete, simply turn off the ignition switch
to exit the program mode.
ERASING TRANSMITTERS IF THEY HAVE BEEN LOST OR STOLEN:
NOTE: Before you begin to erase the lost or stolen transmitter(s), have all
transmitters available that you wish to remain programmed. These will be
used during the program process to identify transmitters that will continue to
be used.
Enter the transmitter program mode:
1 Turn the ignition switch to the “ON” position.
2 Within 10 seconds, press and release the valet/program switch three
times. (Siren emits 1 short chirp indicating channel 1 has been entered)
3 Within 10 Seconds, Press and hold the ARM or ARM/DISARM button of the
first transmitter you wish to remain stored into the control unit until a single
chirp is heard from the siren.
(Repeat this for each transmitter you wish to remain stored in the control
unit).
The receiver stores up to four transmitters. To be certain all transmitter slots
in the receiver are occupied with transmitters you wish to continue to use,
and all others are erased, you will have to fill all four receiver slots. If in step
3 you identified one transmitter, you will have to fill the additional 3 slots. If in
step 3 you identified two transmitters, you will have to fill the additional two
slots, etc...
4 Press and hold any unused button or combination of buttons until a long
chirp is heard from the siren. Release and press the button or button combi-
nation again and again until all remaining slots are full.
Repeat this procedure with the appropriate transmitter buttons for all other
receiver channels.
REPRIORITIZING A TRANSMITTER’S PROGRAMMING:
To reprogram a receiver channel with a different transmitter button once a
code has been stored, there will be two options:
1 Enter the transmitter program mode of the receiver channel to be repro-
grammed. Using any unused button or combination of buttons, push out the
stored code by pressing the unused button until a long chirp is heard, then
repeat 3 additional times. After this, you can add any desired unused trans-
mitter button. This action erases only that particular receiver channel, all
other codes will remain stored.
3