Filter
Top Products
128-6690
2 of 8
As mentioned above, the program mode refers to a Keyless Entry unit which
has no sounding device, you will note mention of a long chirp from the siren.
This reference is for those who program this transmitter into a security
system or into a unit with a sounding device.
TO ENTER THE PROGRAM MODE:
1 Turn the ignition switch to the “ON” position.
2 Within 10 seconds, Press and release the valet/program switch three
times.
(Siren emits 1 short chirp indicating channel 1 has been entered)
3 Within 10 Seconds, Press and hold the Lock button of the first transmitter
you wish to control the Lock & Arm feature of your system until the lights
flash or a long chirp is heard from the siren.
(Repeat this for each transmitter you wish to operate the Lock/Arm feature).
4 Within 10 seconds, press and release the valet program switch one time.
(Siren emits 2 short chirps indicating channel 2 has been entered)
5 Within 10 Seconds, Press and hold the Unlock button of the first transmitter
you wish to control the Unlock/Disarm feature of your security system until
the lights flash or a long chirp is heard from the siren.
NOTE: This channel is used only if you desire separate control of the Lock/
Unlock feature. If you wish to operate the Lock/Unlock features from a single
button, move onto step 6 as whatever button is programmed into channel 1
will control both Lock & Arm/Unlock & Disarm.
(Repeat this for each transmitter you wish to operate the Unlock/Disarm
feature).
6 Within 10 seconds, press and release the valet program switch one time.
(Siren emits 3 short chirps indicating channel 3 has been entered)
7 Within 10 Seconds, Press and hold the Start button, (APS-55TW) or Key
button, (APS-590), of the first transmitter you wish to control Channel 3
output, until the lights flash or a long chirp is heard from the siren.
(Repeat this for each transmitter you wish to operate the Channel 3 output
Remote Start & or Trunk Release)
APS-55TW Programming is complete, Turn Off The Ignition Switch to exit the
program mode.
Note: If programming the APS-590 you may continue onto step 8 if you are
operating a device in the vehicle controlled from the optional output. If not,
Turn off the ignition switch to exit the program mode.
8 Within 10 seconds, press and release the valet program switch one time.
9 Within 10 seconds, Press and hold the Opt. button of the first transmitter
you wish to operate the Optional device of the APS-590.
(Repeat this for each transmitter you wish to operate the Optional output
(APS-590 Only)
APS-590 Programming is complete, Turn Off The Ignition Switch to exit the
program mode.
2