Filter
Top Products
3
I. PREPARATION OF VEHICLE INTERIOR
1. Retract storage cover, remove from location
and lay it in a safe place. See Figure 1.
2. Fold rear seat forward.
3. Install and route all video and audio cables, and
any other added component requirements to their
respective places in the vehicle. Refer to
component installation instructions for wiring
diagrams. The suggested routing of the video
system cable is as follows: Above the headliner
from video system to C-pillar. Down the C-pillar to
the floor. Route the power lead to a fused
accessory controlled source. Connect the ground
lead to the vehicle chassis. Route the remaining
wiring (RCA plugs, Remote Sensor extension, etc.)
to the VCP location. See Figure 2. Connect per
instructions included with the video system. If
video system if to be used as a television, install an
appropriate antenna per instructions included with
the antenna.
II. INSTALLATION OF HOUSING
4. Remove and retain (2) two # 8 X 9/16" screws (item 1
pg 2 ) from VCP housing assembly. Separate VCP
housing (item 4 pg 2) from mounting bracket (item 3
pg 2). Install mounting bracket as shown in Fig. 3.
Secure using (8) eight # 8 X 9/16" screws (item 1
pg 2).
Do not overtighten screws.
FIGURE 1
FIGURE 2
FIGURE 3