Filter
Top Products
Page 1
Model APS 600
Installation Manual
SELECTABLE FEATURES
Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be
certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
Dip Switch Selectable Features :
Switch Number ON Position OFF Position Factory Default
Dip Switch 1 Custom Code Override Valet Switch Override Custom Code Override
Dip Switch 2 Voltage Sense Hardwire Voltage Sense
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch in order to
begin the passive arming sequence.
RF Programmable Features :
Feature Selection 1 Chirp 2 Chirps Default
First 1 SecondDoor Locks 3.5 SecondDoorLocks 1Second
Second Auto LockOn Auto LockOff AutoLock Off
Third Auto UnlockOn Auto UnlockOff AutoUnlock Off
Fourth Headlight OutputOn Headlight OutputOff HeadlightOn
Fifth Passive Door Locks Active Door Locks Passive Locks
Sixth Passive Arming Active Arming Active Arming
To program these selectable features;
Action System Response
Turn ignition on No response
Flip valet switch on then off 3 times 1 Chirp - LED 1 flash
Within 3 seconds, turn ignition Off Short chirp, then long chirp
First Then On 1 chirp = 1 second door locks
Press transmitter button 1 to change 2 chirps = 3.5 second door locks
or
Second Flip valet switch on then off 2 chirps = auto locks off
Press tranmitter button 1 to change 1 chirp = auto locks on
or
Third Flip valet switch on then off 2 chirps = auto unlock off
Press transmitter button 1 to change 1 chirp = auto unlock on
or
Fourth Flip valet switch on then off 1 chirp = headlight output on
Press transmitter button 1 to change 2 chirps = headlight output off
or
Fifth Flip valet switch on then off 1 chirp = passive locks
Press transmitter button 1 to change 2 chirps = active locks
or
Sixth Flip valet switch on then off 1 chirp = passive arming
Press transmitter button 1 to change 2 chirps = active arming
or
Flip valet switch on then off Exit program mode
or
Turn ignition key off Exit program mode
Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the program-
ming will be terminated.