AstroStart VKE-103 Automobile Electronics User Manual


 
To enter or exit Valet
®
Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
®
switch within 10 seconds.
The status LED will light steadily if you are entering
Valet
®
Mode and will turn off if you are exiting Valet
®
Mode.
PANIC MODE
If you are threatened in or near your vehicle, you can attract attention by triggering the system
with your transmitter.
Just press
or for more then five seconds to enter Panic Mode. In Panic Mode, the horn
(if connected) will honk and the parking lights will flash for 30 seconds. To stop Panic Mode at
any time, press
or for 1 second on the transmitter again.
Note: In order for Panic Mode to be effective, the vehicle’s horn (or
optional siren) as well as the vehicle's parking lights must be connected.
Rapid resume logic
The system will store its current state to non-volatile memory. If power is lost and then
reconnected, the system will recall the stored state from memory. This means if the unit is in Valet
Mode and the battery is disconnected for any reason, such as servicing the car, when the battery
is reconnected the unit will still be in Valet Mode. This applies to all states of the system including
panic mode.
Programming options
Programming options control your system's normal, operational set-up. Most options do not
require additional parts, but some may require additional installation labour. This system's
programming options are listed below, with the factory default settings in bold:
Ignition switch-controlled door-locking on or off. With this feature on, the doors will lock 3
seconds after the ignition key is turned on, and unlock when the ignition key is turned off.
Comfort Closure off or on. This option is not available for all vehicles. When programmed on,
and pressing
on the remote, the vehicle will lock and close the windows/sunroof.
See your dealer to see if this is available for your vehicle.
© 2006 Astroflex Electronics – All rights reserved 4