Filter
Top Products
Transmitter functions
The receiver uses a computer-based learn routine to learn the transmitter buttons. This makes it
possible to assign any specific transmitter button, or combination of buttons, to any receiver
function. The transmitter initially comes programmed with the Standard Configuration, but may
also be customized by an authorized dealer. The transmitter buttons indicated in all of the
instructions in this manual correspond to a Standard Configuration transmitter.
STANDARD CONFIGURATION
Button
Pressing
duration
Action Confirmations
1 sec.
The locking function and the deactivation of the
Panic mode is controlled by pressing this button.
Parking lights flashes once.
Horn honks once on every
commands.
5 sec.
The panic mode engages when this button
is depressed for at least 5 seconds.
Panic mode engages.
1 sec.
The unlocking function and the deactivation of
the Panic mode is controlled by pressing this button for 1 second.
Parking lights flashes twice.
Horn honks twice on every
commands.
5 sec.
The panic mode engages when this button
is depressed for at least 5 seconds.
Panic mode engages.
1 sec.
Pressing this button before transmitting any commands
momentarily disables all the audible confirmations.
Audible confirmations
are deactivated.
1.5 sec.
An optional auxiliary function, such as trunk release,
can be controlled by pressing this button for 1.5 seconds.
Parking lights flashes three times.
Horn honks three times on every
commands.
The auxiliary output controls :
1 sec.
An optional auxiliary convenience or expansion function that you have added
to your system can be activated by pressing these buttons simultaneously.
Parking lights flashes four times.
&
The auxiliary output controls :
Using your system
LOCKING
Pressing for one second activates the starter kill (optional) and locks the doors (if connected).
The horn will honk (if connected) and the parking lights will flash once. While the starter kill is
enabled, the status LED will flash once per second. The Failsafe
®
Starter Kill (if installed) will
prevent the vehicle’s starter from cranking.
Note: Manually locking the vehicle does not activates
the Failsafe
®
system, it will only lock the doors.
The system can also be programmed to activate the optional Failsafe
®
Starter Kill automatically
(called AED for Automatic Engine Disable). If the system has been programmed for AED enabled,
the Failsafe
®
Starter Kill will automatically activate 30 seconds after the ignition has been turned
© 2006 Astroflex Electronics – All rights reserved 2