Filter
Top Products
8
MAIN SWITCH
Main switch is usually mounted under dashboard. It is a toggle ON/OFF switch that is used
to cancel start functions.
It does not disable other commands which remain active (alarm, lock/unlock commands,
etc.).
STOP
Refer to the table of command on page 5 to know which button to press.
This command only applies when engine is kept running by Remote Starter.
It is used to stop the run time, the panic mode as well as the alarm condition without disarming the security system.
LOW TEMPERATURE MODE
Press the and buttons simultaneously for 2 seconds.
The command alternatively activates/deactivate Low Temperature mode.
In Low Temperature (Sentinel) mode, system starts your engine automatically when temperature falls below a preset level.
Engine will run for programmed runtime, after which system will wait 2½ hours and then start engine again if temperature is
still below preset level.
When mode is activated:
Parking lights will flash 4 times, then, if temperature is below preset level, engine will start.
If temperature is above preset level, system waits until it goes below preset level before starting.
In the case of a manual transmission vehicle, the system must have detected a valid security sequence to allow the
activation of Low Temperature mode. (See "Safety sequence for manual transmission vehicles" on page 3).
If system cannot execute command (for example, hood is open), confirmation will be different (lights: 3).
When mode is deactivated:
Parking lights will flash twice to confirm that mode is deactivated. Applying brakes deactivates Low Temperature mode.
SETTING THE RUNTIME
Refer to the table of command on page 5 to know which button to press.
Parking lights flash one to four times to indicate selected runtime (see table
opposite).
If you send this command while the ignition circuits are activated (by remote or
key), runtime does not change but confirmation is sent to indicate last selection.
If Low Temperature (Sentinel) mode is already activated when this command is
sent, the command sets or indicates Low Temperature mode runtime.
Note: Runtime is doubled for a diesel engine.
1
A runtime of 2 minutes (4 min. for a diesel engine) is not recommended for most vehicles unless you intend to drive off immediately after the remote start. This
selection is not available in Low Temperature mode.
Number of
flashes
Runtime
1 2 minutes
1
2 4 minutes
3 8 minutes
4 18 minutes