Filter
Top Products
9
DOME LIGHT
Programmable as Active or Inactive during installation.
Dome light will turn on for 30 seconds every time “Unlock” command is sent. This 30-
second duration is cancelled when “Lock” command is sent or brakes are applied.
AUTOMATIC LOCK/UNLOCK
Programmable as Active or Inactive during installation.
This function locks doors when ignition key is in “ON” position, engine is running and
brakes are applied. Doors are unlocked when key is turned from “ON” to “OFF” or when
Continuous Mode is activated.
CAR FINDER
Programmable as Active or Inactive during installation.
This function sounds horn on and off and flashes parking lights to help you locate your
vehicle in a large parking lot or deter potential vehicle thieves or assailants by attracting
attention.
Enter command from table.
Car Finder Mode operates for one minute; you can, however, deactivate it before one
minute is up by repeating command or applying brakes.
CONTROLLED OUTPUT
Programmable as Active or Inactive during installation.
This command controls one of your vehicle’s accessories depending on which one was
connected during installation (headlights, defroster, etc.). For details, consult your
technician.
Enter command from table. Controlled output is activated for one second or one minute,
depending on initial programming. When output has been programmed for one minute,
you can deactivate it by repeating command.
ENGINE RUNTIME
Your engine will stop automatically after a preset time. Parking lights will stay on as long
as engine is running. Runtime is programmable during installation. Manufacturer preset
time is 15 minutes but you can have it changed to suit your needs.