AstroStart 4204 Remote Starter User Manual


 
7
ENGINE RUNTIME
Your engine will stop automatically after a preset runtime (set during the installation). Parking lights will stay on
as long as the engine is running.
TRIGGER INPUT
Your remote starter is equipped with a negative trigger (pulse) input.
This input can be connected to another remote control device or to an AstroStart RST-2
timer output (optional). Part number: 310-903-502.
If this input is connected, consult this device's manual or ask your technician which
command controls the Start/Stop function.
Start/Stop commands received on this input are ignored while engine is running on a
remote start.
All Start/Stop commands triggered on the input act the same as a remote control commands.
CONTINUOUS MODE
Continuous Mode function lets you remove the key from the ignition while leaving the engine running. This
convenient feature allows you to leave your vehicle for short periods of time while climate controls remain on.
To access Continuous Mode, send Start command while engine is idling (see S
TARTING THE ENGINE on page 6).
Parking lights, engine and preset accessories will remain on for the duration of the programmed runtime.
Remove the key, exit vehicle and lock all doors. All safety devices will remain active.
If you return to your vehicle before runtime has elapsed, just turn the key to ON position and press the brake
pedal
.
WHAT STOPS THE ENGINE
For your safety, engine will not start or will stop if:
Your key is in ignition (prevent Start cycle)
Remote control sends a Stop message.
Hood is open.
Brakes are applied.
Engine is over-revving (if programmed Enable at installation).
Alarm detect intrusion.
Main switch is OFF.
MAIN SWITCH
The main switch is usually mounted under the driver side dashboard.
It is a toggle ON/OFF switch that is used to cancel start functions.
It does not disable other commands, which remain active (Alarm
features, Locks, etc.).
STOP
When engine is running on a remote start, you can turn it off by pressing
and
buttons simultaneously. This command also turns off alarm condition.