Filter
Top Products
(+) Park Light Output
Chassis Ground Input
(+) Main Power Input
(+) Ignition Input
(-)Second Unlock Pulse
(-)Trunk Release Output
(-) Horn Honk Output
(-) Starter Kill Output
250ma Maximum Output
250ma Maximum Output
250ma Maximum Output
250ma Maximum Output
Constant 12 volt Input
Ground Input
10 Amp Output
Switched Ignition Input
Antenna - Do Not Ground the antenna wire.
*The 12volt output on the keyless entry connector is not to be used
for anything other than suppling power for voltage inverter’s, and door
lock modules such as the DL-3 and DL-7.
**250ma outputs are low current and are designed to activate relays.
Green
Blue
Lock Output
Unlock Output
(-)250ma Output
(-)250ma Output
12volts For Door Lock Module Only
Note: Do not use the center pin of this connector to power relay
packs. Doing so will damage the output. Always use a fused power
source when installing relays for keyless entry.
Orange
Brown
Gray
Pink
Yellow
Red
Black
White
REMOTE VEHICLE KEYLESS INSTALL MANUAL
PAGE 3
Wiring Diagram