Filter
Top Products
SYSTEM PROGRAMMING - Menu 1
PAGE 22
80 SERIES
OWNER'S MANUAL
DIAGNOSTICS
ALARM STATUS / DIAGNOSTICS
PARK LIGHTS LED FLASHES DIAGNOSTICS / STATUS
3 SLOW FLASHES LED’s ON SOLID SYSTEM IS IN SERVICE MODE.
4 SLOW FLASHES SERIES OF 8 FLASHES NOT SET IN RESERVATION MODE “M” MODELS
5 SLOW FLASHES SERIES OF 5 FLASHES START ATTEMPT WHILE IGNITION IS ON
5 FLASHES SERIES OF 5 FLASHES START ATTEMPT WITH HOOD SWITCH OPEN
6 FLASHES SERIES OF 6 FLASHES START ATTEMPT WITH BRAKE APPLIED
7 FLASHES SERIES OF 7 FLASHES SYSTEM IS IN TACH LOCK OUT (SEE DEALER)
8 FLASHES SERIES OF 8 FLASHES THREE START ATTEMPTS WITH NO START
Diagnostic Mode is a tool that can help trouble shoot a start fault. If the remote starter fails to
start i.e.: the hood is open the park likes will flash a diagnostic code. i.e.: 5 flashes = start
attempt with hood open. If the vehicle does not remote start, count the park light flashes then
compare it to the chart below.
The start fault must be corrected in order for the system to operate correctly. See your dealer
for additional trouble shooting or visit and visit the support page..www.ultrastarters.com
TROUBLE SHOOTING
The LED's do not turn on when Tach Learning?
1) The Tach wire input may be connected to the wrong wire. Check the Tach location and
connection then "reset and relearn".
2) The system may be in Tachless Mode. On TL models the Tach wire connection is optional and
the LED's do not turn on during the 35 second learn procedure.
When I unlock the doors the windows roll down or the Trunk Pops?
This issue is caused by the length of the unlock pulse. To correct this issue program the system
for short door lock pulses. (125ms)
The alarm activates 30-45 minutes after setting it?
To prevent the vehicles battery from going dead the computer will "hibernate" like your home
computer might. In some vehicles this causes the door pin input to change state. The alarm
detects the change of state and activates. A relay must be installed to isolated the door pin
circuit from the alarm.
The starter motor stays engaged to long when remote started?
Reset then relearn the Tach with the transmission in reverse. If the vehicle is tach learned when
the idle is high the starter motor may "drag". Check your ground connection if issues persist.