Filter
Top Products
Recommended Installation Procedures
Mounting the Module
Installing The Led
Installing The Program Button
Connecting The Starter Disable
BEFORE STARTING INSTALLATION:
- Discuss the optional system features with the customer.
- Take a few minutes to review the installation and owners manuals.
- Do a walk around the vehicle and check for any damage.
- If installing a LED discuss the placement with customer before installing.
Never mount the module in the engine compartment. Select a location under the dash to install the
main module. Be certain that the module is securely attached and does not obstruct any
serviceable areas. Mount the module so that it cannot be seen if looking under the dash as it
could be easily unplugged by a thief. The module must be free from all moving parts such as
brake, clutch and gas pedals linkages.
Choose a location that will be highly visible when the LED is installed. Most vehicles are equipped
with knock out panels in the dashboard, these panels are easily removable and can be easily
replaced if necessary. Once the location is picked, use a 5/16th drill bit and drill a hole through the
panel. Test fit the LED into the hole. If the hole was drilled to large, place the LED in the hole and
glue in place from the back of the panel. Plug the Led into the Red connector on the main module.
Choose a location to mount the Program Button. This location should be hidden and not visible from
outside the vehicle. Once the location of the switch is picked, use a 1/4” drill bit and drill a hole.
Remove the nut and push the Program button through the hole. Replace the nut and tighten until
the switch is secure. Plug the valet into the Blue connector.
This system contains a built-in Starter disable relay. The brown starter kill wire from the wire
harness bag will connect to the module as normally connected. (87a & 30) Cut the brown wire in
half, then locate the vehicles starter wire. This wire will switch to 12volts in the crank or start
position only. Cut this wire in half and confirm that the vehicle will not start. Connect the brown
wires, one to each side of the cut starter wire. Route the brown wires to the main module and
connect.
Determine the door pin type. Positive, door pin wire switches to 12 volts when the door is opened.
Negative, door pin wire switches to ground when the door is opened. For positive door, connect one
of the black/white wires to 12volts and the other to the door pin wire. For negative connect one of the
black/white wires to ground and the other to the door pin wire.
Recommended Pre-Installation Procedures
Mounting The Siren
Choose a location in the engine compartment that is away from high heat sources and direct
exposer to water. The siren should be mounted as well as grounded to solid metal. Run the wiring
for the siren so that it can not be seen or reached from below the vehicle.
PAGE 4
SECURITY SYSTEM
INSTALL GUIDE