Filter
Top Products
When the Car Jack Mode is activated the system will start flashing the LED rapidly for five seconds.
The park lights and siren will then activate once every second for 10 seconds in Countdown Mode.
After 10 seconds the alarm will trigger into Full Alarm, the system will no longer respond to the
transmitters and the starter disable output will activate to disable the vehicle from starting.
ACTIVATING SERVICE MODE
1. While the ignition is “ON” press and hold the Program Button for five seconds.
The park lights will flash and the siren will chirp five times to confirm that the
system is in Service Mode.
2. While in Service Mode the remote start functions will be disabled and LEDs will
be “ON” steady. Door locks and trunk release are still operational.
DEACTIVATING SERVICE MODE
1. While the ignition is “ON” press and hold the Program Button for five seconds.
The park lights will flash and the siren will chirp two times to confirm that the
system has exited Service Mode.
2. Remote start functions will return to normal operation.
System Service Mode
Service Mode- By Remote
SERVICE MODE ACTIVATED
1 - Press and release button 4 then hold Button 4 again for 6 seconds until
status LED comes on solid.
NOTE: The siren will chirp 5 times as confirmation.
SERVICE MODE DEACTIVATED
1 - Press and release button 4 then hold Button 4 again for 6 seconds until
status LED turns of.
NOTE: The siren will chirp 2 times as confirmation.
Anti Car Jacking Mode
ACTIVATING CAR JACK MODE
DEACTIVATING CAR JACK MODE
Only program this feature if it specifically requested by the customer. Ensure that user is
fully trained on the operation of this feature. When car jack mode is activated the system
will no longer respond to the remote transmitters. If the starter disable feature was installed
the vehicle will not start.
Program Menu 2, Setting 5
- Type 1- Car Jack Mode will activate if the door is opened while the ignition key is in the “On” position.
Car Jack Mode may also be activated by pressing the # button on the remote transmitter
while the ignition key is in the “On” position.
- Type 2- Car Jack Mode will activate if the ignition key is turned to the “On” position. Car Jack Mode
may also be activated by pressing the # button on the remote transmitter while the ignition
key is in the “On” position.
1.During the Countdown Mode - Turn the ignition key “ON” then press and release the
Program Button one time.
2.After Full Alarm - Turn the ignition key “Off” then “ON” then press and hold the Program
Button until the alarm turns off. (About Eight seconds)
PAGE 11
SECURITY SYSTEM
INSTALL GUIDE