Filter
Top Products
Installation Guide
DIAGNOSTICS
12
If the alarm system is triggered while armed, the system will retain in memory the cause of the trigger. The
diagnostics can then be used to determine what the cause of the trigger was. When disarming the alarm,
the siren/horn will chirp 3 times instead of the usual 2 times to indicate the alarm had been triggered.
The system’s LED will also flash in pulses to indicate which input triggered the alarm.
NOTE: LED status will be cleared when ignition is turned ON. For proper memory clearing, insure to
connect the ignition input to the ignition on the vehicle
Note: While the system is disarmed and the ignition is in the off position, the LED will activate from the
following triggers.
1) The door is opened. The LED will Stay on until the door is closed.
2) The hood is opened. The LED will stay on until the hood is closed.
3) The Shock Senor. The LED will flash when impact is detected.
4) The Aux Sensor. The LED will flash when the input is triggered.
Alarm Diagnostics
Additional LED Flashes
Park Light Flashes LED Flashes Diagnostic
Two Flashes Two Flashes Shock Sensor Triggered
Three Flashes Three Flashes Door Input Triggered
Four Flashes Four Flashes Ignition Input Triggered
Five Flashes Five Flashes Hood Input Triggered
None Off System Disarmed
None On Solid Valet Mode
None Single Flashes System Armed
None Rapid Flashes Passive Arming