Filter
Top Products
Page 8
INSTALLATION MANUAL
REMOTE VEHICLE STARTER
1Tach Detection Mode 1 Flash Set for Tach Detection - Must Connect Tach Wire
*2Tachless Mode 2 Flashes No Tach connection required
Press the Program Button 6 times to select setting 6 (This will be confirmed by 6 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button. Press Program Button momentarily to move to next program step or repeat to
change selection
1 Pulse Once 1 Flash One pulse required to activate the remote starter.
*2Pulse Twice 2 Flashes Two pulses required to activate the remote starter.
Press the Program Button 9 times to select setting 9 (This will be confirmed by 9 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button. Press Program Button momentarily to move to next program step or repeat to
change selection
Setting 6- Tach Selection
Setting 9- Start Trigger Input- Number of pulses to activate Remote Starter
See page 6 for Entering Program Mode.
Setting 7- Adjust For Over-Crank
Setting 8- Adjust For Under-Crank
1 - Enter Program Mode (Ignition ON-OFF-ON-OFF-ON) then press the Program Button.
2 - Press the Program Button - 7 times (Led will start flashing 7 times).
4 - Release the Button - Exit Program Mode and remote start to test.
3 - Hold the Program Button - For 5 seconds until parking lights flash (each time lights flash tach is reduced).
1 - Enter Program Mode (Ignition ON-OFF-ON-OFF-ON) then press the Program Button.
2 - Press the Program Button - 8 times (Led will start flashing 8 times).
4 - Release Program - Exit Program Mode then remote start to test.
3 - Press and Hold Program - For 5 seconds until parking lights flash (each time lights flash tach is increased ).
1 10 Seconds 1 Flash 10 sec Max time that starter will stay engaged
2 3 Seconds 2 Flashes 3 sec Max time that starter will stay engaged
3*5 seconds 3 Flashes 5 sec Max time that starter will stay engaged
Press the Program Button 5 times to select setting 5 (This will be confirmed by 5 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button. Press Program Button momentarily to move to next program step or repeat to
change selection.
Setting 5-Maximum Crank Time