Filter
Top Products
4
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the
system has arrived intact. If any equipment is missing contact your ANTARI dealer
immediately.
Before beginning initial setup of your ANTARI Hazer, make sure that there is no
evident damage caused by transportation. In the event that the unit’s housing or cable
is damaged, do not plug it in and do not attempt to use it until after contacting your
ANTARI dealer for assistance.
Setup
♦ Remove all packing materials from shipping box. Check that all foam and plastic
padding is removed.
♦ Place hazer on a flat surface and remove hazer liquid tank cap.
♦ Note the maximum fluid level mark located on the front of the hazer.
♦ Pour hazer liquid into the liquid tank, being careful not to exceed the maximum fluid
level. DO NOT OVERFILL. Use only ANTARI Hazer Liquid or other
dealer-recommended high-quality hazer fluid . Any other types of fluid can
damage the unit. When liquid level reaches the fill line, place cap back on liquid
tank.
♦ Your hazer may be operated with or without a remote controller. If you will be
controlling your unit remotely, firmly attach the remote control cable to the proper
input.
Operation
♦ Plug power cord into a grounded electrical outlet.
♦ To operate without remote control, simply turn hazer on. Haze emission will begin
automatically.
♦ To operate via remote control, press the appropriate button on the remote to begin
haze emission.
♦ For further information on operating your ANTARI Hazer, see the section
titled, ”Remote Control Operation”.
If your model includes a mounting bracket designed for overhead installation, it may be
installed at floor level or suspended overhead. If the unit is to be mounted using the
bracket, avoid suspending the unit such that haze is emitted directly toward any one’s
face. Whatever installation method you choose, do not allow the unit to have more
than a 15 degree angle of inclination.
Important: Always monitor tank fluid level during operation. Running a hazer with no
fluid can permanently damage the unit.
If you experience low output, mechanical noise or no output at all, unplug immediately.
Check fluid level, the external fuse, remote connection, and power from the wall. If all
of the above appears to be O.K., plug the unit in again. If hazer does not function after
30 seconds, discontinue operation or permanent damage to the unit may result.
Return the machine to your ANTARI dealer. Always drain tank before mailing or
transporting this unit.
Remote Control Operation
♦ HC-1: 10 meter wired multi-function remote controller with ¼” stereo plug for the
ANTARI Hazer HZ-300. Its two knobs allow the operator to program hazer