Filter
Top Products
POINTS TO OBSERVE FOR SAFE USAGE
Read this manual carefully before using this system. It
contains instructions on how to use this product in a safe
and effective manner. Alpine cannot be responsible for
problems resulting from failure to observe the instructions
in this manual.
This manual uses various pictorial displays to show you
how to use this product safely and to alert you to potential
dangers resulting from improper connections and operation.
Following are explanations of these pictorial displays. It is
important to fully understand the meanings of these pictorial
displays in order to use this manual and the system properly.
DO NOT OPERATE ANY FUNCTION THAT
TAKES YOUR ATTENTION AWAY FROM
SAFELY DRIVING YOUR VEHICLE.
Any function that requires your prolonged attention should
only be performed after coming to a complete stop. Always
stop the vehicle in a safe location before performing these
functions. Failure to do so may result in an accident.
KEEP THE VOLUME AT A LEVEL WHERE YOU CAN
STILL HEAR OUTSIDE NOISE WHILE DRIVING.
Failure to do so may result in an accident.
MINIMIZE DISPLAY VIEWING WHILE DRIVING.
Viewing the display may distract the driver from looking
ahead of the vehicle and cause an accident.
DO NOT DISASSEMBLE OR ALTER.
Doing so may result in an accident, fire or electric shock.
USE THIS PRODUCT AS SPECIFIED.
Use for other than its designed application may result in
fire, electric shock or other injury.
KEEP SMALL OBJECTS SUCH AS BATTERIES
OUT OF THE REACH OF CHILDREN.
Swallowing them may result in serious injury. If swallowed,
consult a physician immediately.
DO NOT PLACE HANDS, FINGERS OR FOREIGN
OBJECTS IN INSERTION SLOTS OR GAPS.
Doing so may result in personal injury or damage to the
product.
USE THE CORRECT AMPERE RATING
WHEN REPLACING FUSES.
Failure to do so may result in fire or electric shock.
DO NOT BLOCK VENTS OR RADIATOR PANELS.
Doing so may cause heat to build up inside and may result
in fire.
HALT USE IMMEDIATELY IF A PROBLEM APPEARS.
Failure to do so may cause personal injury or damage to the
product. Return it to your authorized ALPINE dealer or the
nearest ALPINE Service Center for repairing.
Temperature
Be sure the temperature inside the vehicle is between +45°C
(+113°F) and -0°C (+32°F) before turning your unit on.
Fuse Replacement
When replacing the fuse(s), the replacement must be of
the same amperage as shown on the fuse holder. If the
fuse(s) blows more than once, carefully check all electrical
connections for shorted circuitry. Also have your vehicle’s
voltage regulator checked.
Servicing the Unit
If you have problems, do not attempt to repair the unit
yourself. Return it to your ALPINE dealer or the nearest
ALPINE Service Station for servicing.
Installation Location
Make sure the PND-K3 will not be exposed to:
• Direct sun and heat • Excessive dust
• High humidity • Excessive vibrations
Characteristics of LCD Panel
• After turning the system off, a slight ghost of the
image will remain temporarily. This is an effect
peculiar to LCD technology and is normal.
• Under cold temperature conditions, the screen may
lose contrast temporarily. After a short warm-up
period, it will return to normal.
• The LCD panel is manufactured using an extremely
high precision manufacturing technology. Its effective
pixel ratio is over 99.99%. This means that 0.01% of
the pixels could be either always ON or OFF.
Using Headphones
If ACC or the monitor’s power source is turned off, a loud
noise may be produced through the headphone jack. Be
sure to remove the headphones from your ears before you
turn the monitor off.
3
WARNINGS