Reference [Phrase Looping]
ZOOM MRS-802
65
• Deleting numbers or symbols
Use the cursor left/right keys to move the cursor (flashing
segment) to the desired position and press the [DELETE/
ERASE] key.
When formula input is complete, specify a track/V-take on
which to store the phrase loop as audio data.
NOTE
• The formula for a phrase loop is stored as part of a project
also after writing the result to a track/V-take. Therefore you
can edit and reuse the formula later.
• For a phrase loop that has already been written to a track/
V-take, it is not possible to write it again in part or to add
another phrase loop. In such a case, specify the entire
phrase again as a formula and write the entire phrase
again.
Writing a phrase loop to a track
This section explains how to create a phrase loop and write it
as audio data to a specified track/V-take.
1.
From the main screen, press the [UTILITY] key in
the display section.
The utility menu appears on the display.
2.
Use the cursor left/right keys to bring up the
indication “UTILITY PHRASE” on the display, and
press the [ENTER] key.
The display changes as follows.
3.
Press the [UTILITY] key in the display section once
more.
The phrase utility menu appears on the display.
4.
Verify that the indication “PHRASE CREATE” is on
the display, and press the [ENTER] key.
If “PHRASE IMPORT” is shown, use the cursor left/right
keys to call up “PHRASE CREATE” and press the
[ENTER] key.
The display changes as follows. This screen lets you select a
track/V-take for writing the phrase loop.
5.
Use the cursor up/down keys and the dial to select
the track/V-take to which to write the phrase that
will be created.
When track 8 is selected, turning the dial further to the right
brings up the following screen.
When this screen is shown, turning the dial to the right
selects tracks in odd-numbered/even-numbered pairs (1/2,
3/4, 5/6, 7/8) or the master track. In this case, the currently
selected V-take for the two tracks or the master track
becomes the writing target.
NOTE
• If the phrase is monaural and the write target track is
stereo, the same data will be written to both tracks.
• If the phrase is stereo and the write target track is mono,
the left and right channels of the phrase will be mixed
when the data are written to the track.
• When a V-take which already contains audio data is
selected, the existing data will be completely erased and
overwritten by the new audio data.
6.
When you have selected a track/V-take, press the
[ENTER] key.
A screen for selecting the phrase loop number appears.
PHRASE
REST
0
PHRASE
CREATE
CREATE
TR 1- 1
CREATE
TR 8- 1
CREATE
TR1/2
CREATE
LOOP01
