6. Before conducting full operation of
your unit, allow it to warm up at
low speed for two to three
minutes.
When changing the position from
right to left side, or from left to right
side position, be sure to stop the
engine and place the frame on the
ground. Change the orientation of the
shaft and carry the frame on the back
again.
Do not change the orientation of
the shaft while carrying the unit on
the back. Otherwise, accidental
injury may occur.
(1) Right side
(2) Left side
■ STOPPING THE ENGINE
• Stop the engine immediately in
an emergency.
• The blade rotates by inertia for a
while after the engine has
stopped. Do not touch the blade
until the engine has stopped
completely.
• Do not touch the muffler or
spark plug with bare hands
immediately after the engines
has stopped. Otherwise you
may suffer burns because the
muffler and spark plug are
extremely hot.
If you stop the engine while keeping
the revolution speed high, the engine
could become damaged. Return the
throttle lever to its original position
and reduce the engine speed before
stopping the engine except in an
emergency.
1. Return the throttle lever to the
idling position.
2. Set the engine stop switch to
“stop.”
(1) Stop switch Press “Stop”
IMPORTANT
