30
GM 3000AC
OPERATING MANUAL
EDITION 05/2007
PART NO. DOC364831
Note:
Methylene chloride is not recommended as a fl ushing or cleaning solvent with this gun or
any system components.
1. Relieve the pressure from the gun and unit.
2. Secure gun with trigger safety catch.
3. Replace material with cleaning agent.
4. Remove and clean the AirCoat nozzle. (see section 5.4.3)
5. Pressurize the cleaning supply to approx. 4 MPa; 40 bar; 580 psi max. and thoroughly
fl ush the spray gun.
6. Relieve spray gun and unit pressure!
7. Secure gun with trigger safety catch.
8. Clean gun body with a cleaning agent recommended by the manufacturer, and dry
with a cloth.
6.1 FINISHING WORK AND CLEANING
DANGER
Exploding gas/ air mixture!
Danger to life from flying parts and burns
Never spray into a closed container.
Earth the container.
SIHI_0008_GB
CAUTION
Cleaning agent in the air duct!
Functional faults caused by swollen seals
Always point the spray gun down when cleaning.
Ensure that neither paint nor cleaning agent enters the air duct.
SIHI_0005_GB
7!2.).'
%XPLOSIVEATMOSPHERE
%XPLOSIVEGASESAREPRODUCEDWHENALUMINIUMCOMESINTOCONTACT
WITHHALOGENIZEDHYDROCARBONS
4OCLEANALUMINIUMDONOTUSELIQUIDSCONTAININGHALOGENIZED
HYDROCARBONS
3)()??'"
